ron123

Finally figured it out.... I purchased a 2017 MKX Premiere without DRLs in the lower bumper. I had the dealer enable Daytime Running Lights through the software to which enable the headlamp Signature lights to light during the day (in Auto Mode). Purchased a factory DRL assembly and learned that wire assembly 15K867 with connector 129/130 exists in my MKX. Removed the splash pan to gain access to the connectors. Plug in the DRL assembly into one of the connectors. Tested by enabling DRL in Configurable settings in Auto Mod then placed vehicle in 'N' and made sure that the headlamps were not lite. The DRLs did not light. So the DRL is defective or there may be an additional setting code required through the software. Please let me know if anyone has any additional suggestions. Thanks,

Thanks for this insight. I did not realize that theses buck boost were available. I don't think that I would want to add another device to my MKX. Would you know why these factory DRLs require a higher voltage?? Was thinking abut replacing the internal LEDs in the factory DRL with a standard 12 volt after market but that would be a extreme measure. Whatever I do, it needs to be reliable b/c I have to pay the body shop to drop the front bumper to install a pair of factory DRLs. Thanks, Ron

Thanks for the follow-up. I did bench test between pins 1 & 6 and the DRL would not light until I increased the voltage to 16 volts. If they are digital as you mentioned, then I guess these fixtures can not be connected to the battery via a control relay. I wanted to add DRL to my 2017 MKX Premier which has the cutouts in the bumper but does not contain the required wiring assembly. It appears that I have to abort the project. Thanks again.for your comments...

I just purchased the OEM DRLs to add to my 2017 MKX. Does anyone know of a procedure to test these by have them illuminate before they are installed? There are 6-pins on the DRL labeled 1 - DRL LED ANODE (+) 2 - LED SENSE 3 - DRL/NTC- 4 - Bin SENSE 5 - NTC SENSE 6 - DRL LED CATHODE (-) Thanks

Here's a related posting that I posted on the MKC Forum... I have found myself in a similar situation wanting the factory DRLs in my 2017 MKX Premiere and was told by the dealer that the wiring did not exist in the Premiere so I was planning on purchasing an aftermarket control module to power the factory DRLs. Seeing the cutouts in the lower bumper area inspired me to purchase a factory DRL assembly. I removed the lower splash panel and was immediately faced with obstructions but did note that there was a wired mating connector in place that should plug into the DRL. Seeing the obstructions I backed out of my attempt and simply replaced the splash panel. I also purchased the MKX 2017 Factory Wiring manual and learned that pin-1 is the + and pin-6 is the - on the 6-pin DRL connector which would be useful in connecting the after market controller. I don't know if I was successful in installing the DRL if it would have worked with existing wiring. I did have the dealer program the Signature LEDs around the head lamps light during the day in DRL mode. Please let me know if anyone was successful in getting the OEM DRLs installed. I realize that this is a MKC forum but thought it may help others. Regards, rlh

Has anyone tried to install the factory DRLs (LEDs below the headlights) after market?

I just picked up my new 2017 MKX a couple of weeks ago and did not notice until yesterday that there is an excessive Buffeting Wind Noise with the driver's window down while driving 50 - 60 mph. The noise seems to reduce when I open another window. Has any experienced this problem? I will do some additional driving to see if I can get any additional info. Thanks for feedback.

I contacted my local Lincoln service department asked if they would be willing to install roof rails on my 2017 MKX, They refused to add the roof rails because it involves drilling holes in the roof and dropping the headliner. With that, I don't want to take any changes with a custom shop, so I will pass on the addition and save the $1,000 + bucks.

I also would like to add the satin rails to my new 2017 MKX. From what I have been able to learn the rails can be purchased separately from www.tascaparts.com: Part # FA1Z-5855106-AD (RH) https://www.tascaparts.com/oem-parts/ford-rail-roof-rack-cross-fa1z5855106ad Part # FA1Z-5855107-AD (LH) https://www.tascaparts.com/oem-parts/ford-rail-roof-rack-cross-fa1z5855107ad These are not sold as a set just separately Right hand side and Left hand side. I understand that instructions are included which I have been unable to obtain. I don't know how involved it would be to do a self install. I would think that it requires drilling holes and dropping the headliner which I would be reluctant to perform on my new MKX. So a custom shop or the dealer might be the best choice for installation. I was told that it take about 1-1/2 labor to install. I will contact my local Lincoln dealer next week to see what they would charge to install my pre-purchased rails. I will post the follow-up. If anyone has any additional information, please post. Both are available and has to be special ordered directly from the automotive manufacturing plant. Resupply would arrive with in 3-5 business days once your order has begun processing. Regards, Ron

I just learned from the model year and built date that the AN engine harness to the headlamps and DRLs is not available for my Premier model.

I just purchase a 2017 MKX Premier and it did not come with the factory installed DRLs in the lower bumper, only what Lincoln calls Signature Lights which are located around the headlamps. I had to have the dealer activate the DRL function in the software so that the Signature Lights would operate during the day when in 'Auto Lamps' mode. I have been looking into installing the DRLs in the lower bumper and need to determine if the wiring is in place. I hope my understanding is correct. Feedback welcome. Thanks,

i just got back from the dealer. They were able to enable the DRL function through their software tool. Now the Signature Lights LEDs light up during the day without DRLs installed and the function can be controlled through the left hand settings. I would like to know if anyone was able to install the factory DRLs in their 2017 MKX. I see the knock-out plugs in the lower bumper and what appears to be a cable with a socket behind that area. Any info would be appreciated.

I will check to see if the dealer would be willing to enable the DRLs through the software to see if that would provide the option of running the Signature Lights during the day. It appears that the DRLs can be easily be added to the MKX Premier. I see knockouts in the bumper and what appears to be a cable with plugs in the area.

Would anyone know if I have the dealer activate non-existent DRLs in a 2017 MKX would the Signature Lights light during the day when in the Auto Lamps mode? (They currently do not light during the day.)

I just called the Lincoln. Apparently the feature is only available with vehicles that have DRLs option. Please acknowledge if anyone had a success in getting these turned on without the DRLs installed. Thanks,